Vtp database not updating egyptian dating website
Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.
Visit Stack Exchange I recently replaced the switch that was functioning as the VLAN server for the rest of the network.
Reference: switches are running VTPv1 so they cannot share the MST configuration with each other (only VTPv3 supports MST).
Therefore in order to share the same MST with DSW2, DSW1 must be manually configured with the same region name, revision number and VLAN-to-instance mapping with DSW2.
VTP Source 2: “Version-Dependent Transparent Mode—In VTP version 1, a VTP transparent switch inspects VTP messages for the domain name and version and forwards a message only if the version and domain name match.
Although VTP version 2 supports only one domain, a VTP version 2 transparent switch forwards a message only when the domain name matches.” Verification: ######### CORE01#sh vtp status VTP Version : running VTP2 Configuration Revision : 14 Maximum VLANs supported locally : 1005 Number of existing VLANs : 17 VTP Operating Mode : Server VTP Domain Name : TEST VTP Pruning Mode : Enabled VTP V2 Mode : Enabled VTP Traps Generation : Disabled MD5 digest : 0x49 0x30 0x4E 0x43 0x02 0x B2 0x36 0x7A ######### Make a change to the VTP database and then verify that the Revision number has incremented and has updated across the transparent switch.
It’s always a good idea to verify what the documentation is saying by setting up a practice lab.
VTPv3 supports for extended VLAN range (VLANs 1006 to 4094).
VTP Source 1: “Version-dependent transparent mode; transparent mode no longer checks domain name.
This enables support of more than one domain across a transparent domain.” Some of the newer documentation states to the contrary.
Which means the trunks will continue to forward traffic properly for the next 5 minutes.
Problem: Some of the older documentation and study guides state that VTP domains don’t need to match when set to version 2 transparent.
VTP versions 1 and 2 only supports VLANs 1 to 1005.